An oven here can sit unused for three weeks and then be asked to cook for fourteen people on a holiday weekend. That is when the failures show up, and that is the worst possible day for them. We repair ovens and ranges, gas, propane and electric, across Highland Lake Estates, Bar-K Ranches, Country Club Estates, Lago Vista Estates and Lakeside at Tessera. Diagnostic is 99 dollars and goes toward the repair.

Common causes. On an electric oven it is usually the bake element, a failed relay on the control board, or one leg of the 240 volt supply missing. On a gas oven the igniter is the most common part in the whole appliance: as it ages it glows but no longer draws enough current to open the gas valve, so you get heat from the igniter and nothing else.
What we do. We measure current draw through the igniter rather than judging it by how bright it looks. A weak igniter looks perfectly normal to the eye, and that is why it gets missed.
Common causes. A drifted oven sensor, a sensor touching the cavity wall, a door that no longer seals, or a control that has been calibrated away from true by someone over the years.
What we do. We measure actual cavity temperature against the setpoint through a full cycle, then check the sensor resistance cold. Baking complaints are usually measurable, not a matter of opinion.
Common causes. A weak igniter on gas, a partly failed element on electric, a door seal letting heat out, or on propane a regulator or orifice set for natural gas, which leaves the burner short of the heat it should make.
What we do. We time the preheat, measure the burner or element, and on propane verify the conversion under load with other appliances running.
Common causes. An overheating control board, a cooling fan that stopped, a sensor reading out of range, or a door latch the control does not trust. Codes point at a circuit, not at a part.
What we do. We read the code, then test the circuit behind it. We check the cooling fan early, because a board cooked by a dead fan will fail again if the fan is left alone.
Common causes. On electric, a failed broil element or its relay. On gas, the broil burner igniter or the valve. On many models bake and broil run through separate relays, so one working proves nothing about the other.
What we do. We test the broil circuit on its own rather than assuming the control is fine because the oven bakes.
Common causes. Worn or sagging hinges, a flattened door gasket, or glass panels that have shifted. A door that does not seal shows up as slow preheat and uneven baking long before anyone notices the door itself.
What we do. We check hinge wear and the gasket all the way around, and replace what is actually letting heat out.
Common causes. This is common enough to be its own category. Self-clean runs the cavity far hotter than baking and regularly takes out a thermal fuse, the door lock motor or the control board. The oven works fine, you clean it before guests arrive, and then it is dead.
What we do. We check the thermal fuse and the lock assembly first, since those are the usual victims, then the board. We will also tell you plainly whether self-clean is worth running again on your model.
Common causes. On a gas range the burners run off the manifold with no electricity needed, while the oven needs power, the igniter and the control. So working burners and a dead oven often means a power or control problem, not a gas problem.
What we do. We check supply voltage and the oven control circuit. People often assume a gas issue here, and it rarely is.
Freestanding and slide-in ranges, wall ovens single and double, gas on natural gas and propane, electric, convection and combination units. Common brands here include Whirlpool, KitchenAid, Maytag, GE, Frigidaire, LG, Samsung, Bosch, Thermador and Wolf.
Wall ovens take longer than ranges because the unit has to come out of the cabinet and go back in square. We plan for that rather than rushing it.
Diagnostic is 99 dollars for a residential unit and is credited toward the repair when you approve the work. The final price depends on the part, whether the oven has to come out of a cabinet, and whether gas work is involved.
Work carries a 3 month labor warranty and installed parts carry a 1 year manufacturer defect warranty. On a unit where the repair costs more than it is worth we say so instead of quoting it.
Highland Lake Estates, Bar-K Ranches, Country Club Estates by the golf course, Lago Vista Estates south of Lohman Ford Road, Lakeside at Tessera, and the streets off Boggy Ford Road and American Drive. We also cover Point Venture and Jonestown, and run along FM 1431 toward Leander and Cedar Park.
Yes. The oven burner has its own orifice and the regulator has to be set for propane. A conversion that was never verified under load shows up as slow preheat and low temperature, which look like part failures.
Not the day before. If something is going to fail from the heat, that is when it fails, and you are left with no oven. Clean it manually when the timing matters.
Not the oven itself, but problems go unnoticed. It is worth running the oven once before a holiday weekend rather than finding out on the day.
Same-day or next-day in most cases. Around holidays we book up faster, so call as early as you can.
Call or book online and tell us whether the unit is gas, propane or electric, and the error code if there is one. EPA certified and insured.
We repair all major residential appliance brands across Central Texas, including Whirlpool, GE, Samsung, LG, Maytag, Frigidaire, KitchenAid, Amana, Bosch, Electrolux, Hotpoint, Kenmore, Haier, Fisher & Paykel, Sub-Zero, Wolf, Viking, Thermador, JennAir, Dacor, U-Line, Marvel, Miele, and GE Monogram.