Two things make cooktops here different from the rest of the metro: much of Lago Vista cooks on propane rather than natural gas, and a lot of hoods vent through a blower sitting in the attic or on the roof rather than in the hood itself. Both change what is actually wrong when something stops working. We repair gas, electric and induction cooktops and vent hoods across Highland Lake Estates, Bar-K Ranches, Country Club Estates, Lago Vista Estates and Lakeside at Tessera. Diagnostic is 99 dollars and goes toward the repair.

Common causes. A burner cap seated wrong or a port blocked by boil-over is the first thing to check and costs nothing. After that it is a cracked igniter, moisture in the switch, or a spark module firing all burners at once because one switch is shorted.
What we do. We clean and reseat the cap, then watch which burners spark. All of them clicking together points at a switch, not at the burner you were using.
Common causes. On propane this usually means the conversion was never finished properly. Natural gas orifices left in place, or a regulator still set for natural gas, give a tall soft yellow flame and soot on the pans. It can also be a blocked port or air shutter.
What we do. We check the orifices and the regulator setting against what the appliance actually runs on, and verify pressure under load with the oven and other burners going. A conversion that looks right at idle can still fail when the whole range is in use.
Common causes. On radiant tops it is a failed element, an infinite switch, or a burnt terminal block connection. On induction it is more often the control board, a cooling fan that stopped, or cookware the unit will not recognize.
What we do. We measure voltage at the terminal block and resistance at the element before touching the board. Burnt connections at the block get blamed on the cooktop far too often.
Common causes. Induction tops shut down when they overheat, and the usual reason is a blocked cooling path or a fan that failed, not the electronics. Codes can also point to a sensor or a power board.
What we do. We read the code, check the fan and the air path under the unit, then test the sensors. Boards are expensive and should be the last conclusion, not the first.
Common causes. Greased-over filters, a duct run with too many elbows, a roof or wall cap with a stuck damper, or a remote blower that is running at reduced speed. There is also a cause that has nothing to do with the hood: a tightly built house with no makeup air simply cannot let the hood move the air it is rated for.
What we do. We check filters and the duct, confirm the damper opens, and test the blower itself. If the house is starving the hood we say so, because no new hood will fix that.
Common causes. On a hood with a remote or inline blower, a dead hood very often means a live hood and a dead blower sitting in the attic or on the roof. Beyond that it is the control board, the switch panel, or a wiring connection at the blower.
What we do. We find where the blower actually lives before condemning the hood. This one mistake gets hoods replaced that never needed replacing.
Common causes. A blower wheel loaded unevenly with grease, worn motor bearings, loose mounting, or a damper flapping in the wind. Roof-mounted blowers also catch wasp and bird nests in houses that sit empty part of the week.
What we do. We pull and clean the wheel, check the bearings and the mounting, and inspect the exterior cap.
Common causes. Cracked glass is usually impact or thermal shock and is a replacement, not a repair. Dead touch controls are often moisture under the panel or a failed touch board, and sometimes a control lock nobody meant to turn on.
What we do. We rule out the control lock and moisture first, then test the touch board. On cracked glass we tell you the part cost honestly before you decide.
Gas cooktops on natural gas and propane, radiant electric, induction, downdraft units, and wall, island, under-cabinet and outdoor-rated hoods with built-in, inline or remote blowers. Common brands here include Whirlpool, KitchenAid, GE, Frigidaire, Bosch, LG, Samsung, Thermador, Wolf, Vent-A-Hood and Broan.
Outdoor kitchens on covered patios are common on the lake, and outdoor-rated hoods and burners corrode differently from indoor units. We treat them as their own job, not as an indoor hood that happens to be outside.
Diagnostic is 99 dollars for a residential unit and is credited toward the repair when you approve the work. The final price depends on the part, whether a remote blower has to be reached in the attic or on the roof, and whether gas work is involved.
Work carries a 3 month labor warranty and installed parts carry a 1 year manufacturer defect warranty. We quote before the work starts.
Highland Lake Estates, Bar-K Ranches, Country Club Estates by the golf course, Lago Vista Estates south of Lohman Ford Road, Lakeside at Tessera, and the streets off Boggy Ford Road and American Drive. We also cover Point Venture and Jonestown, and run along FM 1431 toward Leander and Cedar Park.
Yes, and it is worth checking. Orifices and regulator setting both have to match propane, and we verify pressure with the appliance under load rather than at idle.
Often no. If the house has a remote or inline blower, the hood can be perfectly fine and the blower in the attic or on the roof is what failed. We check that before anything else.
Yes. Outdoor units fail mostly from corrosion, heat and insects rather than from use, and they need different parts than the indoor equivalents.
Same-day or next-day in most cases. Gas work and attic blowers take longer on site, so we schedule them with enough time to finish properly.
Call or book online and tell us whether the cooktop is gas, propane, electric or induction, and where the hood blower is if you know. EPA certified and insured.
We repair all major residential appliance brands across Central Texas, including Whirlpool, GE, Samsung, LG, Maytag, Frigidaire, KitchenAid, Amana, Bosch, Electrolux, Hotpoint, Kenmore, Haier, Fisher & Paykel, Sub-Zero, Wolf, Viking, Thermador, JennAir, Dacor, U-Line, Marvel, Miele, and GE Monogram.