On a commercial line two local facts decide most of the faults we find. Much of Lago Vista cooks on propane, so every burner on the line depends on a conversion being correct, and many hoods here exhaust through a blower on the roof rather than in the hood itself. A dead hood very often means a live hood and a dead rooftop blower. We service restaurants, clubs, marinas and event kitchens across Lago Vista, Point Venture and Jonestown. Commercial diagnostic is 149 dollars and goes toward the repair. EPA certified and insured.

Common causes. A dirty or weak flame sensor, a failed thermopile on standing pilot ranges, a clogged pilot orifice, or a gas valve not holding. A pilot that blows out when the hood runs is a different problem: the kitchen is short of makeup air and the hood is pulling the flame out.
What we do. We measure flame signal in microamps and test the valve, and we check whether the pilot drops out specifically when the hood is on, because that points away from the range entirely.
Common causes. On propane this points at the conversion. Orifices sized for natural gas, a regulator set wrong, or air shutters never adjusted give soft yellow flames and soot on the pans. One bad conversion explains several unrelated looking complaints on the same line.
What we do. We verify orifices and regulator against the fuel the appliance actually runs on and set combustion properly, with the whole line firing rather than one burner at a time.
Common causes. Grease-loaded filters, a duct that has not been cleaned, a blower wheel caked with grease, a damper stuck, or a makeup air unit that is not running so the kitchen cannot supply the air the hood is trying to move.
What we do. We check the filters, the blower wheel and the damper, and verify the makeup air side. A hood cannot exhaust air the building does not let in.
Common causes. On a kitchen with a rooftop or inline blower, the hood is often fine and the blower is not: a failed motor, a seized bearing, a bad capacitor or a tripped disconnect on the roof. Beyond that it is the control panel or a contactor.
What we do. We find where the blower actually lives and test it there. Diagnosing a hood from the kitchen alone is how dead rooftop blowers get missed.
Common causes. Negative pressure. The hood is exhausting far more air than the makeup air system supplies, so the building pulls air through every gap. It makes burners misbehave, pilots drop and doors stick.
What we do. We identify whether the complaints are a pressure problem rather than an appliance problem, and say so plainly. Chasing burner parts in a negatively pressured kitchen wastes money.
Common causes. A blower wheel loaded unevenly with grease, worn bearings, loose mounting, or a backdraft damper flapping. Rooftop units also collect nests in houses and buildings that sit quiet part of the week.
What we do. We pull and clean the wheel, check bearings and mounts, and inspect the exterior cap and damper.
Common causes. Partially blocked burner ports, warped burners or radiants, low manifold pressure when several appliances fire together, or a griddle thermostat out of calibration.
What we do. We clean and inspect the burners and measure manifold pressure under full load, and calibrate griddle thermostats against measured plate temperature.
Common causes. Suppression systems, their gas shutoff interlocks and their inspections are a licensed specialty, separate from appliance repair.
What we do. We do not work on suppression systems, and we will tell you when a fault belongs to your suppression contractor rather than taking the job. We can work alongside them on the appliance side.
Range tops, griddles, charbroilers, hot plates and salamanders on natural gas, propane and electric, plus exhaust hoods with built-in, inline and rooftop blowers. Common brands include Vulcan, Garland, Imperial, Star, Wolf, Southbend, Captive-Aire and Greenheck.
Outdoor and patio cooking lines on the lake corrode differently from indoor equipment, and we treat them as their own job rather than as an indoor range that happens to be outside.
Commercial diagnostic is 149 dollars and is credited toward the repair when you approve the work. The final price depends on the part, whether a rooftop blower has to be reached, and whether gas work is involved.
Work carries a 3 month labor warranty and installed parts carry a 1 year manufacturer defect warranty. We quote before the work starts.
Lago Vista including the marina and club areas, Point Venture, Jonestown, and out along FM 1431 toward Leander and Cedar Park. We also cover Lakeway and Bee Cave on the south shore.
That is a makeup air problem, not a range problem. The hood is pulling more air out than the kitchen can replace, and no burner part will fix it.
Usually not. If the blower is on the roof or inline, the hood itself is often fine. We check the blower before anything else.
Hood and duct cleaning is a separate licensed trade and we are not it. We repair the equipment and will tell you when what you actually need is a cleaning contractor.
Same-day wherever we can. Gas work and rooftop blowers take longer on site, so we schedule enough time to finish properly.
Call or book online and tell us the equipment, the fuel, and where the hood blower is if you know. Commercial diagnostic 149 dollars, applied toward the repair.