A wine cooler is the appliance most likely to fail without anyone noticing, and in Lago Vista that matters more than almost anywhere. A house closed up for two weeks does not announce that the cellar unit stopped holding temperature. You find out when you open it. We repair built-in and freestanding wine coolers and beverage centers across Highland Lake Estates, Bar-K Ranches, Country Club Estates, Lago Vista Estates and Lakeside at Tessera. Diagnostic is 99 dollars and goes toward the repair.

Common causes. On a compressor unit it is a start relay, a condenser fan, a dirty condenser or a sealed system problem. On a thermoelectric unit it is usually a failed Peltier module or its fan. The two types fail completely differently and have to be diagnosed differently.
What we do. We establish which type the unit is before anything else, then work the cheap causes first: condenser, fans, relay. Sealed system work is the last conclusion, not the first.
Common causes. A failed thermostat or temperature sensor, a control board stuck calling for cooling, or a unit installed somewhere much colder than it expects.
What we do. We measure the actual cabinet temperature against the setpoint over a full cycle and test the sensor cold. Freezing is as much a failure as not cooling, and wine does not recover from it.
Common causes. A door seal that no longer seals, a sensor placed badly or drifted, or a dual zone unit where one zone damper has failed. In a lakeside house with glass doors, afternoon sun on the unit is also a real factor.
What we do. We log temperature over time rather than reading the display once, which is the only way to tell a sensor problem from a load or a seal problem.
Common causes. A condenser packed with dust, a built-in unit with blocked ventilation, high ambient temperature, or a seal letting warm air in. Built-ins installed into an island or cabinet without the clearance the manufacturer requires run hot their whole life.
What we do. We clean and inspect the condenser and check the ventilation path around the cabinet. If the installation is strangling the unit, we say so, because no part replacement fixes a ventilation problem.
Common causes. A blocked defrost drain, a failed door seal, or humidity getting in every time the door opens in a hot house. Dual pane glass that has lost its seal fogs permanently and is a door replacement.
What we do. We clear the drain, check the seal all the way around, and tell you honestly if the fogging is inside the glass itself.
Common causes. A condenser or evaporator fan with a worn bearing, a compressor mount that has gone soft, or the unit simply not sitting level. Vibration also rattles bottles, which bothers people long before the noise does.
What we do. We find which component makes the noise and check the leveling and mounts before quoting parts.
Common causes. A sagging hinge on a heavy glass door, a flattened gasket, or a shelf or bottle stopping the door quietly. A door slightly open explains most complaints about temperature and condensation at once.
What we do. We check hinge wear and the gasket, adjust or replace, and verify the door actually pulls closed on its own.
Common causes. A control board, a sensor out of range, or simply LED strips that have failed. On many units the lighting is independent of cooling, so dark inside does not mean the unit is dead.
What we do. We read the code and test the sensors, and treat lighting as the separate circuit it usually is.
Built-in undercounter units, freestanding cabinets, dual zone coolers and beverage centers, both compressor and thermoelectric. Common brands here include Sub-Zero, U-Line, Perlick, Thermador, EdgeStar, Danby, Whirlpool and Avanti.
Outdoor and patio beverage centers are their own case. An indoor-rated unit installed in an outdoor kitchen will struggle in summer no matter how well it is maintained, and that is worth knowing before parts get replaced.
Diagnostic is 99 dollars and is credited toward the repair when you approve the work. The final price depends on the part, whether the unit has to come out of cabinetry, and whether the sealed system is involved.
Work carries a 3 month labor warranty and installed parts carry a 1 year manufacturer defect warranty. On a small thermoelectric unit a sealed repair rarely makes sense and we will tell you that plainly.
Highland Lake Estates, Bar-K Ranches, Country Club Estates by the golf course, Lago Vista Estates south of Lohman Ford Road, Lakeside at Tessera, and the streets off Boggy Ford Road and American Drive. We also cover Point Venture and Jonestown, and run along FM 1431 toward Leander and Cedar Park.
You usually do not until you open it. A simple wireless temperature sensor inside the cabinet, checked from your phone, is the cheapest insurance there is for a collection of any value.
Check the ventilation first. Built-in units vent through the front and need the clearance the manufacturer specifies. Installed into a cabinet opening meant for a different unit, they overheat and never cycle off.
Sometimes. A fan or a sensor is worth doing. A failed Peltier module on an inexpensive unit usually is not, and we will say so rather than quote it.
Same-day or next-day in most cases. Tell us the brand and whether it is built in, and we will bring what the common failures need.
Call or book online and tell us the brand, whether the unit is built-in or freestanding, and what temperature it is actually holding. EPA certified and insured.
We repair all major residential appliance brands across Central Texas, including Whirlpool, GE, Samsung, LG, Maytag, Frigidaire, KitchenAid, Amana, Bosch, Electrolux, Hotpoint, Kenmore, Haier, Fisher & Paykel, Sub-Zero, Wolf, Viking, Thermador, JennAir, Dacor, U-Line, Marvel, Miele, and GE Monogram.