Ice is not a luxury on the north shore in July, and it is usually the first thing that fails. Hard Hill Country water scales an ice maker faster than almost anything else in the kitchen, and a unit that sits unused for a week between visits scales even quicker. We repair refrigerator ice makers and standalone undercounter units across Highland Lake Estates, Bar-K Ranches, Country Club Estates, Lago Vista Estates and Lakeside at Tessera. Diagnostic is 99 dollars and goes toward the repair.

Common causes. A closed or partly closed saddle valve, a plugged inlet valve screen, a water filter nobody has changed, or a frozen fill tube. On refrigerator units a failed ice maker module or a shut-off arm stuck in the park position will also stop production completely.
What we do. We check supply pressure at the valve first, then fill volume, then the module. A new ice maker on a starved water line makes exactly as much ice as the old one did.
Common causes. This is the classic hard water complaint here. Scale builds on the mold and the fill path, the fill slows, and the harvest happens before the cube is full. Low supply pressure and a clogged filter do the same thing.
What we do. We time the fill and measure how much water actually enters the mold. If the cause is scale we deal with the scale and tell you what the water is doing, instead of selling you a new ice maker that will scale the same way by spring.
Common causes. Ice absorbs odor, and in a house that sits closed up between weekends a half-full bin of old ice picks up everything around it. Beyond that it is an old filter, a long run of plastic supply line, or a bin that needs cleaning.
What we do. We check the filter and the supply line and clean the bin and mold. If the unit is fine we say so rather than inventing a repair.
Common causes. A fill tube that freezes over means water is arriving when it should not be, usually a weeping inlet valve, or the fill volume is too high. A mold frozen solid points at the thermostat or the harvest heater.
What we do. We test the inlet valve for seepage with the power off, check fill volume, and test the harvest circuit. Chipping the ice out without finding the cause buys you about a week.
Common causes. A split or kinked supply line, a cracked filter housing, a leaking inlet valve, or on standalone units a blocked drain. In a house nobody visits for days this is the failure that does real damage, because the water runs the whole time.
What we do. We trace the line from the shutoff to the unit, pressure check it, clear or repair the drain, and look at what the water reached.
Common causes. Ice that is not used refreezes together. That is normal in a second home. It becomes a repair when the cause is a slow leak into the bin, a door seal letting warm air in, or a defrost problem raising the freezer temperature.
What we do. We check the seal, the freezer temperature and the fill for seepage before touching anything else.
Common causes. Outdoor kitchens and covered patios are common on the lake, and an ice maker rated for a cool indoor cabinet will not hold its rated output at 100 degrees. Add a condenser loaded with caliche dust from the roads out here and production falls off hard.
What we do. We service the condenser, check the air clearance around the cabinet, and measure actual output against the plate rating. If the unit is simply not an outdoor-rated machine, we tell you that plainly.
Common causes. A cube jammed behind the ejector, a worn gear in the module, a failed motor, or on standalone units a cutter grid or auger problem.
What we do. We find which part is binding before ordering anything, since a jam and a dead module are not the same repair.
Refrigerator ice makers in side-by-side, French door and bottom freezer units, standalone undercounter ice makers indoors and in outdoor kitchens, and nugget and gourmet cube machines. Common brands here include Whirlpool, KitchenAid, Maytag, GE, Frigidaire, LG, Samsung, Scotsman, U-Line and Sub-Zero.
Commercial ice machines in bars, clubs and short-term rental properties are a different service — see our commercial ice machine page.
Diagnostic is 99 dollars for a residential unit and is credited toward the repair when you approve the work. The final price depends on the part, whether the water line and valve need work, and whether the unit is built in.
Work carries a 3 month labor warranty and installed parts carry a 1 year manufacturer defect warranty. We quote before we start.
Highland Lake Estates, Bar-K Ranches, Country Club Estates by the golf course, Lago Vista Estates south of Lohman Ford Road, Lakeside at Tessera, and the streets off Boggy Ford Road and American Drive. We also cover Point Venture and Jonestown, and run along FM 1431 toward Leander and Cedar Park.
Yes, both. Outdoor and patio units are common here and they fail differently from refrigerator ice makers, mostly from heat and airflow rather than from the ice maker itself.
The water is hard. Scale coats the mold and the fill path, which is why cubes come out hollow and production drops. A softener or a dedicated filter on the ice line slows it down considerably.
If the house sits empty for weeks, turning the ice maker off and closing the water valve is reasonable. It avoids a slow leak running unnoticed and keeps old ice from sitting in the bin absorbing odors.
Same-day or next-day in most cases. Because the drive is longer we come stocked for the common failures so the repair finishes on the first visit.
Call or book online and tell us what the ice maker is doing. EPA certified and insured.
We repair all major residential appliance brands across Central Texas, including Whirlpool, GE, Samsung, LG, Maytag, Frigidaire, KitchenAid, Amana, Bosch, Electrolux, Hotpoint, Kenmore, Haier, Fisher & Paykel, Sub-Zero, Wolf, Viking, Thermador, JennAir, Dacor, U-Line, Marvel, Miele, and GE Monogram.