A prep table is really two refrigeration problems in one cabinet: the base, which behaves like any undercounter cooler, and the rail, which has to hold pans of food at temperature with the lid open through an entire service. They fail separately and get diagnosed separately. On a patio line in August the rail is fighting the weather as well. We service restaurants, bars, clubs, marinas and event kitchens across Lago Vista, Point Venture and Jonestown. Commercial diagnostic is 149 dollars and goes toward the repair. EPA certified and insured.

Common causes. This is the most common prep table complaint and it is usually not the refrigeration. Pans sitting too high in the wells, pans not the right size so cold air escapes, a rail fan that stopped, or a lid left open all service. On units where the rail has its own evaporator, that coil can be iced while the base is fine.
What we do. We measure product temperature in the pans and air temperature in the rail, then check pan fit, lid discipline and the rail coil and fan. We do not touch the charge until the air side is ruled out.
Common causes. A dirty condenser, a failed condenser or evaporator fan, a door gasket gone, defrost not clearing the coil, or low charge from a leak.
What we do. We clean and inspect the condenser, verify both fans and the defrost cycle, and then take pressures. Adding refrigerant to a unit that simply cannot reject heat hides the real fault.
Common causes. A failed defrost component, doors or lids open constantly in a humid kitchen, a gasket letting warm air in, or low charge.
What we do. We test the defrost circuit and check the seals. Melting the ice without finding the cause gets you through one service.
Common causes. A blocked condensate drain, a cracked drain pan, or a condensate pump that stopped. Food debris in the drain is the usual blockage on a prep table.
What we do. We clear the drain line, test the pump, and check what the water has been reaching under the unit.
Common causes. A condenser packed with grease and dust, a unit pushed tight against a wall or line with no airflow, high kitchen temperature, or a failed condenser fan. Prep tables often sit in the hottest part of the line with the least clearance.
What we do. We clean the condenser and check the clearance around the cabinet. Sometimes the fix is where the unit sits, not what is inside it.
Common causes. Torn gaskets, a warped lid, or a hinge that no longer holds the cover closed between tickets. A rail cover that does not close is a temperature problem no part will fix.
What we do. We replace gaskets and repair hinges and covers so the unit can actually hold temperature when the line is quiet.
Common causes. A sensor fouled or out of range, a sensor placed where it reads air rather than product, or a controller that lost settings after a power event.
What we do. We verify the display against a measured temperature before replacing anything, because a unit holding fine with a bad sensor is a different job from a unit genuinely warm.
Common causes. An indoor-rated unit on a covered patio in August, direct sun on the cabinet, or no air clearance behind the line. Lake patios run service in conditions most prep tables were never rated for.
What we do. We service the unit and tell you plainly whether it can hold food safe in that spot, because that is a food safety question before it is an appliance question.
Sandwich and salad prep tables, pizza prep tables, mega top units, undercounter refrigerated bases and chef bases. Common brands include True, Turbo Air, Beverage-Air, Continental, Delfield, Traulsen and Randell.
For seasonal kitchens, a prep table that sat idle comes back with a dry gasket and a dirty condenser, and that shows up on the first hot weekend rather than on the first quiet one.
Commercial diagnostic is 149 dollars and is credited toward the repair when you approve the work. The final price depends on the part, access to the compartment, and whether sealed system work and refrigerant are involved.
Work carries a 3 month labor warranty and installed parts carry a 1 year manufacturer defect warranty. We quote before the work starts.
Lago Vista including the marina and club areas, Point Venture, Jonestown, and out along FM 1431 toward Leander and Cedar Park. We also cover Lakeway and Bee Cave on the south shore.
Often not. Pan fit, pan depth and an open lid account for most warm rail complaints. We measure before we quote parts.
It can be. Most prep tables are rated for an indoor kitchen temperature, and summer on the lake is well past that. We will tell you what yours can realistically hold out there.
Yes. We measure product temperature in the pans, which is the number that matters for an inspection, not the display on the front.
Same-day wherever we can. Tell us the brand and whether the rail or the base is the problem when you call.
Call or book online and tell us the brand and what the unit is holding. Commercial diagnostic 149 dollars, applied toward the repair.