An oven that will not reach temperature, a broiler that never fires, a self-clean cycle that locked the door and quit, or a range that throws a fault code the moment you turn it on. TakiDA repairs gas, electric and dual-fuel ovens and ranges across Dripping Springs and the surrounding Hill Country. Same-day slots are usually available, and the diagnostic is applied to the repair.
Call (737) 388-3867 | Request a visit

Common causes. A bake element with a hidden break, a weak gas igniter that no longer pulls enough current to open the safety valve, a temperature sensor reading high, or a door gasket letting heat escape faster than the element can replace it.
What we do. We measure the sensor resistance cold and compare it against the manufacturer's curve, read igniter current while the valve is trying to open, and check the element and gasket. That tells us which part is actually short, instead of replacing a board on a guess.
Common causes. A failed control board relay, a thermal fuse opened by a blocked vent, a broken door switch the control reads as open, or on an electric range one leg of the 240 volt supply lost at the breaker.
What we do. We confirm both legs of the supply at the terminal block with the meter in low-impedance mode, test the fuse and door switch, and only then look at the board. A range that has lost one leg will run the lights and clock perfectly while the oven stays stone cold, which is why this check comes first.
Common causes. A convection fan that has stopped turning, a sensor out of calibration by thirty degrees or more, a broil element cycling when it should not, or a rack position that never suited the recipe.
What we do. We log the actual cavity temperature against the setting through a full cycle with an infrared thermometer, check the convection motor and its baffle, and recalibrate or replace the sensor. You get the measured offset, not an opinion about the oven running hot.
Common causes. This is the classic one. Self-clean drives the cavity past 800 degrees, and the heat regularly takes out the thermal fuse, the door lock motor or the control board on the same cycle.
What we do. We check the fuse, lock assembly and board in that order, release a door still latched, and tell you honestly whether the oven is worth the repair. Where the model has a known self-clean weakness we will say so, so you can decide whether to use that cycle again.
Common causes. The cooktop and the oven run on separate igniter circuits, so a weak oven igniter, a stuck safety valve, or a propane conversion left half done will kill the oven while the burners work fine.
What we do. We measure igniter draw and valve response, verify the regulator and orifices match the fuel the house runs on, and replace the igniter or valve based on the reading. On propane homes outside the city gas lines this conversion check is routine for us.
Common causes. A shorted sensor circuit, a keypad ribbon that has lifted, a board damaged by a surge, or a loose harness connector behind the console.
What we do. We read the code, look it up against the model's service chart, and test the circuit the code points at before touching the board. Codes name a symptom, not a part, and we treat them that way.
Common causes. Worn hinges, a stretched or torn gasket, a bent inner panel, or a spring that has lost tension so the door sags open an inch.
What we do. We replace the hinges, springs or gasket, square the door, and confirm the seal closes evenly all around. A sagging door costs real baking time and real gas, so it is worth fixing properly.
Common causes. Moisture under the glass, a cracked control ribbon, a failed infinite switch, or a board output stuck high.
What we do. We dry and reseat the connections, test the panel through its service routine, and measure each element and switch. The failing part gets named by measurement before anything is ordered.
Freestanding and slide-in ranges, wall ovens single and double, gas, electric and dual-fuel, convection and conventional, plus warming drawers and built-in ovens in custom cabinetry. We service Whirlpool, KitchenAid, Maytag, GE, Frigidaire, Bosch, Samsung, LG, Thermador, Wolf and Dacor, including units running on propane out past the city gas lines.
The diagnostic is $99 for a home and $149 for a commercial kitchen, and it is credited toward the repair when you approve it. Elements, igniters, sensors, fuses, hinges and door switches are moderate parts. Control boards and door lock assemblies are the expensive end, and on an older range we will tell you when the repair stops making sense against a replacement. You get a written estimate with parts, labor and tax before any work starts, and it stays good for 30 days. Labor carries a 3 month warranty and installed parts carry one year against manufacturer defects.
We cover Dripping Springs and the neighborhoods around it, including Belterra, Caliterra, Headwaters, Rim Rock and Sunset Canyon, along with the properties out along Ranch Road 12 and Highway 290 West. Nearby Driftwood, Henly and Wimberley are inside our normal route, and Bee Cave, Lakeway and Austin are a short run from here.
Usually yes. Most ovens have a calibration offset you can set, and where the drift is larger than the offset allows the temperature sensor is the part at fault. We measure the real cavity temperature first so the adjustment is based on a number rather than on how a cake came out.
On many models it is the single hardest thing you can ask the oven to do, and it is a common reason for a dead control board. If your model has that history we will tell you, and a manual clean with the oven warm costs you nothing in parts.
Shut the gas off at the appliance valve, open a window, and do not run it. Call us and we treat it as urgent. A gas smell is a leak or a failed safety valve, and neither waits for a convenient appointment.
Same-day slots are usually open, and next-day is the normal worst case. Give us the brand, the model and the fault code if there is one, and we will bring the likely parts with us.
Tell us the brand, what the oven is doing, and whether the house runs on natural gas, propane or electric, and we will bring the parts most likely to finish the job on the first visit.
We repair all major residential appliance brands across Central Texas, including Whirlpool, GE, Samsung, LG, Maytag, Frigidaire, KitchenAid, Amana, Bosch, Electrolux, Hotpoint, Kenmore, Haier, Fisher & Paykel, Sub-Zero, Wolf, Viking, Thermador, JennAir, Dacor, U-Line, Marvel, Miele, and GE Monogram.