Empty bin, cubes coming out small or hollow, ice fusing into a lump, or water running down the freezer wall. We repair refrigerator, undercounter and freestanding ice makers across Georgetown. The $99 residential diagnostic is credited toward the repair.

An ice maker that used to fill the bin and now makes half as much is usually losing either water or cold, not both. We measure the fill volume and the time it takes, then check what the freezer is actually holding, because a freezer running a few degrees warm will slow the harvest cycle without ever setting a fault.
The shape of the cube tells you about the fill. Short fills give small cubes, slow fills give hollow ones, and cloudiness usually comes down to what is in the water rather than the machine. Georgetown water carries enough mineral to show up in ice, and a filter that is past its date makes it worse.
Ice absorbs odour, and old cubes absorb more. Before replacing anything we look at how long the ice has been sitting, whether the bin seals, and when the filter was last changed. It is often not a repair at all, and we will say so.
That means the ice partly thawed and refroze. A door that is not sealing, a bin that sits where warm air reaches it, or a harvest cycle that is running too often will all do it. The fix depends on which, and guessing wastes a visit.
It is making ice and failing to release it. On most designs a small heater warms the mold just enough for the cubes to let go, and when that heater fails the cycle completes with the ice still in place. That is a measurable fault, not a judgement call.
The fill tube is overshooting or freezing, and the water is finding its way out before it reaches the mold. There is a small heater on that tube on most units for exactly this reason, and when it fails the tube ices and water backs up.
With the arm or sensor ruled out, the question is whether the unit is getting water and whether it is getting the signal to start. Those are two separate checks and we do them in that order, because a dry ice maker will never cycle no matter what the control says.
That is the selector and the crusher assembly rather than the ice maker itself. It is a cheap area to work in, and worth knowing before anyone starts talking about replacing the ice maker.
We work on the ice maker inside the refrigerator, undercounter and freestanding units, and the water line, filter and inlet valve that feed them. Common brands in Georgetown homes include Whirlpool, GE, Samsung, LG, KitchenAid, Frigidaire, Maytag, Bosch and Electrolux.
If the unit is undercounter or in an outdoor kitchen, say so when you book. Those run in a different environment and fail differently from one sitting inside a refrigerator.
The residential diagnostic is $99 and comes off the repair when you approve it. Inlet valves, fill tube heaters, mold heaters, thermostats, sensors and water lines are modest. A complete ice maker assembly costs more, and we tell you which one you are looking at before anything is ordered.
Water quality matters here more than most places. A filter that is overdue affects taste, cube clarity and valve life all at once, and changing it is the cheapest repair there is.
Ice maker calls come from every part of Georgetown — Sun City, Wolf Ranch, Water Oak, Berry Creek, Serenada, the older houses around the Square and San Gabriel, and out toward Cimarron Hills. Summer is the busy season: a unit that coped through winter cannot keep up once the house is fighting triple digits, and what looks like a sudden failure is often a slow decline that the heat finally exposed.
Almost always worth repairing. The ice maker is a small assembly with its own parts, and a fault there says nothing about the condition of the refrigerator.
Every six months is the usual recommendation, and with the water here that is a floor rather than a target. An overdue filter shows up in the taste first and in the valve later.
The freezer works harder, the harvest cycle slows, and a unit that was marginal in January cannot keep up in August. It is often the same underlying fault, just finally visible.
Yes. Tell us which it is when you book — they have their own parts and their own failure patterns, and we would rather bring the right ones.
Often same day. Have the refrigerator brand and model number ready, plus when the filter was last changed.
Tell us the refrigerator brand and model, whether the unit is inside the fridge or undercounter, and when the filter was last changed. That decides what goes on the van.
We repair all major residential appliance brands across Central Texas, including Whirlpool, GE, Samsung, LG, Maytag, Frigidaire, KitchenAid, Amana, Bosch, Electrolux, Hotpoint, Kenmore, Haier, Fisher & Paykel, Sub-Zero, Wolf, Viking, Thermador, JennAir, Dacor, U-Line, Marvel, Miele, and GE Monogram.