Bee Cave kitchens tend to pair a high-output range or cooktop with a large hood and a blower mounted somewhere other than the hood itself, often inline in the attic or out on the roof. That design is quieter and more powerful, and it also means a hood that stopped working may have nothing wrong with it at all.

On a system with a remote or inline blower, the hood controls and the blower are separate pieces connected by wiring that runs through the house. The hood can respond perfectly while the blower in the attic or on the roof is dead, or while the control signal is not reaching it. That is why a non-working hood here starts with finding where the blower actually lives.
Professional burners put out far more gas than a standard range, and they are less forgiving of a blocked port, a shifted cap or the wrong orifice. Yellow and lazy means the air and gas mixture is wrong. On a cooktop converted between natural gas and propane the orifices are the first thing to check rather than the last.
Induction tops protect themselves. Most shutdowns are the cooling fan, a blocked air inlet under the counter, or a temperature sensor rather than the generator board. Pan material and size matter too: a pan smaller than the ring or not magnetic reads as no pan. Codes point somewhere specific, so the code is read before anything is ordered.
Negative pressure. A powerful hood in a tightly built house pulls more air than the house can replace, so it comes in through every gap. In homes with gas appliances that is also a combustion safety issue. The fix is usually the makeup air system rather than anything in the hood.
Downdraft systems fight physics and they only work when everything is right: the blower, the damper, the duct run under the floor, and a pot height that does not defeat it. Most downdraft complaints are a damper that is not opening fully or a duct that has collected grease, not a dead motor.
Cycling is normal up to a point, since the element switches on and off to hold the setting. When it happens constantly the element is failing, the infinite switch is worn, or the surface limiter is cutting in because the glass is running hot. Glowing on high and barely warm on low points to the switch.
A chip at the edge spreads under heat, and a crack across the surface means the top is no longer sealed against spills reaching the wiring underneath. That is a replacement rather than a repair, and on a modular cooktop system the replacement has to match the cutout.
Heat and grease take out lamps, sockets and switch contacts, and on systems with a remote blower there is also wiring between the hood and the motor that can fail anywhere along its run. Sorting out whether the fault is at the hood, in the wiring, or at the blower is most of the diagnosis.
Sealed gas burner and professional burner cooktops, induction, radiant glass, downdraft island cooktops, teppanyaki and griddle modules, modular cooktop systems, and the hoods above them including inline and remote blowers and makeup air units. Common brands include Wolf, Thermador, Sub-Zero, Monogram, Viking, Miele, Bosch, Gaggenau, Vent-A-Hood, Zephyr and Best.
Gas work is done to manufacturer specification, and a conversion between natural gas and propane gets verified rather than assumed. We do not clean ducts, and we will tell you when that is what the problem is.
The diagnostic is ninety nine dollars for a residential call and it is credited toward the repair once you approve the work. Igniters, spark modules, infinite switches, elements, blower motors, capacitors, dampers and filters are routine parts. On a cracked glass top or a failed induction generator board the part cost starts to approach a new cooktop, and we will say so plainly with both numbers in front of you.
A modular or built-in cooktop is matched to the cutout and the surround, so repairs are often clearly worth doing where a standard unit would be replaced.
Spanish Oaks, Falconhead, Lake Pointe, Uplands, Homestead, Ladera, Bella Colinas, Sweetwater, Rough Hollow nearby, and the homes along Bee Cave Road and Highway 71.
On many systems here it is inline in the attic or mounted on the roof rather than inside the hood. Knowing that before the visit saves time, and it is also why a hood can be dead while the hood itself is fine.
If the hood moves a large volume of air and the house is tightly built, yes, and in many cases code required it at construction. Doors that pull hard and backdrafting are the signs that it is missing or not working.
Every one to three months depending on how you cook. Baffle filters go in the dishwasher. Clean filters are the cheapest way to keep a hood capturing properly and to slow grease buildup in the duct.
It should be corrected. Yellow means incomplete combustion, which produces carbon monoxide and soot. It is usually a blocked port or a wrong orifice rather than anything exotic, but it is not something to keep cooking on.
Yes. Give us the model and serial when booking so parts availability and lead time can be checked before the visit.
Tell us the brand, whether the cooktop is gas, induction or radiant, and whether the blower is in the hood or mounted remotely, and we can usually narrow it down before we arrive. Call (737) 388-3867 or book online. The ninety nine dollar diagnostic is credited toward the repair.
We repair all major residential appliance brands across Central Texas, including Whirlpool, GE, Samsung, LG, Maytag, Frigidaire, KitchenAid, Amana, Bosch, Electrolux, Hotpoint, Kenmore, Haier, Fisher & Paykel, Sub-Zero, Wolf, Viking, Thermador, JennAir, Dacor, U-Line, Marvel, Miele, and GE Monogram.