The cookline and the hood above it are one system, and in Pflugerville the failures usually show up at the hood end first: a kitchen that gets smoky, doors that pull hard, pilots that blow out. All three are symptoms of exhaust and makeup air being out of balance rather than of the equipment underneath.

Clogged burner ports, a pilot out of position, a weak thermocouple or a gas valve that is not opening fully. On an open burner range the ports fill with boil-over and carbon over a few months of service, and a burner that lights around only part of its ring is almost always telling you about that rather than about a failed part.
Each zone on a flat top has its own burner or element and its own thermostat with its own capillary bulb. A zone that runs cold while the rest are right isolates to that circuit. On a well-used griddle the bulb can also come loose from the plate, which reads as a temperature fault even though nothing has failed.
Radiants out of position, a burner that has shifted, or ports blocked by grease. Charbroilers are the dirtiest piece on the line and the first to lose even heat. Realigning radiants and clearing burners is maintenance rather than repair, and it is most of what these need.
Capture and containment rather than fan speed. Filters loaded with grease, a fan that has lost speed through a slipping belt, ductwork needing cleaning, or makeup air that is not replacing what the hood is pulling. A hood sounds the same whether it is moving design airflow or a fraction of it.
Classic negative pressure. The exhaust is pulling more than the makeup air unit is supplying, so the building makes up the difference through every opening it has. It is worth fixing for the energy cost alone, and it is also what puts out pilots on the equipment below the hood.
Belts, bearings and mounts on the rooftop fan. These live in Texas sun and grease, and a belt that has glazed slips long before it breaks, which means the hood is quietly moving less air for weeks. Fans get serviced rather than waited on.
Heat and grease take out lamps, sockets and switch contacts over time. These are small repairs that matter because a line cook who cannot see the plate works slower and a hood with a dead switch often ends up left running all night.
Filters that are loaded or missing, a grease cup that is overflowing, or a hood that has gone too long between cleanings. This crosses from equipment into fire safety, and it is where we will tell you plainly if what you need is a hood cleaning service rather than a repair.
Gas ranges and open burner tops, flat top griddles, charbroilers and radiant broilers, hot plates and stock pot ranges, electric ranges and French tops, salamanders and cheese melters, wok ranges, and the exhaust hoods, fans and makeup air units above them. Common brands include Vulcan, Garland, Imperial, Southbend, Wolf, Star, American Range, CaptiveAire and Greenheck.
Gas work is done to manufacturer specification, and a conversion between natural gas and propane gets verified rather than assumed. We do not perform hood cleaning, and we will say so and point you at it when that is what the problem actually is.
Restaurants, taquerias and bars along Pecan Street and FM 685, fast casual at Stone Hill Town Center, school and daycare kitchens, churches and event venues, convenience stores with hot food programs, and food trailers.
The commercial diagnostic is one hundred forty nine dollars and it is credited toward the repair once the work is approved. A cookline down in the middle of service is urgent and gets treated that way.
Daily to weekly depending on what you cook. Charbroilers and fryers load filters fastest. Clean filters are the cheapest way to keep a hood capturing properly and to slow grease buildup in the duct.
Usually loaded filters, a slipping fan belt, or makeup air that is not keeping up. The hood sounds identical in all three cases, which is why airflow gets checked rather than assumed from the noise.
No. We repair the equipment, the fans, the controls and the makeup air side. Grease cleaning of hoods and ductwork is a separate certified service and we will tell you when that is what the problem is.
Yes, including belts, bearings, motors and controls. Tell us when booking if roof access needs a ladder, a hatch key or notice to building management.
Usually. Burners, valves, pilots, thermocouples, thermostats and griddle plates are all serviceable, and commercial ranges are built to be rebuilt. We will tell you when a repair stops making sense rather than quoting it anyway.
Tell us what the equipment is, whether it is gas or electric, and whether the problem is on the cookline or at the hood, and we can usually narrow it down before we arrive. Call (737) 388-3867. The one hundred forty nine dollar commercial diagnostic is credited toward the repair.