Washers in Lago Vista work harder than most. Wet towels off the boat and the pool are the heaviest load a home machine ever sees, and houses that are rented out by the weekend run their laundry like a small hotel. We repair front load and top load washers across Highland Lake Estates, Bar-K Ranches, Country Club Estates, Lago Vista Estates and Lakeside at Tessera. Diagnostic is 99 dollars and goes toward the repair.

Common causes. The drain pump filter is the usual culprit, and on the lake it fills with sand, lake grit and hair out of towel loads faster than people expect. After that it is a blocked drain hose, a failed pump, or a pressure sensor that never sees the water level drop.
What we do. We pull and clean the filter, check the pump for continuity and for anything jammed in the impeller, and verify the drain line is not kinked or pushed too far down the standpipe.
Common causes. A load the machine cannot balance is first, and a drum full of heavy wet towels is exactly that. Beyond load balance it is a worn drive belt, a failed motor control board, a lid lock or door lock the machine does not trust, or worn suspension rods letting the drum hit the cabinet.
What we do. We watch the machine try to ramp up to spin, which tells us quickly whether it is a balance problem, a lock problem or a drive problem. Each one is a different repair and a different price.
Common causes. Worn suspension rods or shock absorbers, failed drum bearings, shipping bolts never removed after delivery, or a machine that is simply not level on a garage slab. A heavy towel routine wears suspension parts years earlier than a normal household does.
What we do. We level the machine, check the suspension and spin the drum by hand to feel the bearing. A bearing that is going makes a specific grinding noise that nothing else makes, and we will tell you honestly whether that repair is worth doing on your model.
Common causes. A door or lid lock that no longer latches, a control board, a failed water inlet valve so the machine waits forever to fill, or on older units a worn lid switch.
What we do. We check the lock circuit and the fill before condemning the board. Boards get blamed for a lot of failures that are not theirs.
Common causes. A split supply hose, a leaking door boot on front load machines, a cracked detergent dispenser, or a drain hose that backed up. In a house that sits empty between visits a slow leak runs for days, and on a second floor laundry it reaches the ceiling below.
What we do. We run the machine and find where the water actually comes from rather than guessing from the puddle, then repair that point and check the hoses that have not failed yet.
Common causes. Front load machines that sit shut between weekends grow mold in the boot and the dispenser. Hard water and heavy detergent dosing make it worse, because the residue feeds it.
What we do. We clean the boot, dispenser and drain path, replace the gasket when it is past cleaning, and tell you the dosing and door routine that actually stops it coming back.
Common causes. Codes point to a circuit, not to a part. Drain codes, fill codes, lock codes and unbalance codes all have several possible causes behind them.
What we do. We read the code, then test the circuit it points at. Tell us the code when you call and we will usually know what parts to bring.
Common causes. Inlet screens clogged with scale and sediment, a partly closed supply valve, low pressure, or a pressure sensor and hose that read the level wrong. Hard water quietly plugs those inlet screens over a couple of years.
What we do. We measure fill rate at the machine, clean or replace the inlet screens and valve, and check the pressure hose for a blockage.
Front load and top load, high efficiency and traditional agitator machines, stacked laundry centers and side by side pairs. Common brands here include Whirlpool, Maytag, LG, Samsung, GE, Frigidaire, Speed Queen, Bosch and Electrolux.
Laundry rooms in rental properties see commercial-level use even with household machines, and we service them the same day where we can, because a dead washer on a changeover day is a cancelled booking.
Diagnostic is 99 dollars for a residential machine and is credited toward the repair when you approve the work. The final price depends on the part, how far the cabinet has to come apart, and whether the drum has to come out.
Work carries a 3 month labor warranty and installed parts carry a 1 year manufacturer defect warranty. On a machine where the repair does not make financial sense we say so instead of quoting it.
Highland Lake Estates, Bar-K Ranches, Country Club Estates by the golf course, Lago Vista Estates south of Lohman Ford Road, Lakeside at Tessera, and the streets off Boggy Ford Road and American Drive. We also cover Point Venture and Jonestown, and run along FM 1431 toward Leander and Cedar Park.
Yes, and we understand the changeover deadline. Give us access instructions and a contact number and we will work around guest schedules where we can.
Wet towels are heavy and they hold water, so the drum carries far more weight during spin than the machine was designed around. That load goes straight into the suspension and the bearings, and it is the main reason lake house washers wear out early.
Yes. Scale plugs the inlet screens, coats the heating element on machines that have one, and leaves residue in the drum and dispenser that turns into odor. It does not break the machine outright, it shortens its life.
Same-day or next-day in most cases. We come stocked for the common failures so the repair finishes on the first visit whenever possible.
Call or book online and tell us what the washer is doing, and the error code if there is one. EPA certified and insured.
We repair all major residential appliance brands across Central Texas, including Whirlpool, GE, Samsung, LG, Maytag, Frigidaire, KitchenAid, Amana, Bosch, Electrolux, Hotpoint, Kenmore, Haier, Fisher & Paykel, Sub-Zero, Wolf, Viking, Thermador, JennAir, Dacor, U-Line, Marvel, Miele, and GE Monogram.