Almost every microwave we are called out to in Pflugerville is mounted over the range, and that unit is doing two jobs: heating food and venting the cooktop below it. When one of the two stops, people usually describe it as a microwave problem even when the fault is in the hood side, and those are different repairs.

The turntable spins, the light is on, the fan runs, and nothing heats. That is the high voltage side: magnetron, diode, capacitor or transformer. It is the most common microwave failure there is, and it is also the one repair that should never be attempted at home, because the capacitor holds a lethal charge after the unit is unplugged.
Start with the outlet and the breaker, then the internal fuse. A blown line fuse rarely blows on its own: it usually goes because a door interlock switch failed and shorted, so replacing only the fuse puts the unit back in the same place a week later. That is why a dead microwave gets the door switches checked rather than just a fuse.
On a combination unit the fan is driven from the same control board as the microwave. A fan that is dead while the microwave still heats is usually the fan motor, the speed switch or the board. On top of that, most of these were installed recirculating rather than ducted, so a fan that runs perfectly can still feel like it is doing nothing.
Stop using it. Arcing comes from a burned waveguide cover, metal in the cavity, or a chipped spot where the paint has gone and the steel underneath is exposed. The waveguide cover is an inexpensive part and the repair is routine, but running a unit that arcs damages the magnetron, which is not inexpensive.
Usually the turntable motor, the coupler under the plate, or debris in the track. Simple to confirm and inexpensive to fix. Worth doing rather than ignoring, because a unit that does not rotate heats unevenly and gives you cold spots in the middle of everything.
Door interlock switches again. There are usually three of them and they have to act in sequence. When one fails out of order the unit behaves unpredictably: running with the door open, refusing to start with it closed, or stopping mid-cycle. This is a safety circuit rather than a convenience, so it gets repaired rather than bypassed.
The membrane keypad above a range takes years of steam and grease and eventually the traces fail. A keypad is a replaceable part on most models. If the display itself is flickering or scrambled rather than the buttons, the control board is the more likely one.
A magnetron on the way out often gets loud before it quits, and a failing high voltage transformer buzzes under load. Either way, a microwave that has become noticeably louder than it used to be while heating is telling you something, and it is worth looking at before it stops entirely in the middle of a dinner.
Over-the-range combination units, built-in microwaves with trim kits, microwave and wall oven combinations, drawer microwaves and countertop units. Common brands include Whirlpool, GE, Samsung, LG, Frigidaire, KitchenAid, Maytag, Bosch and Sharp.
On over-the-range units we check the hood side as well as the microwave side, including the filters and whether the unit is ducted or recirculating, because that is often where the real complaint is.
The diagnostic is ninety nine dollars for a residential call and it is credited toward the repair once you approve the work. Door switches, fuses, waveguide covers, turntable motors, fan motors and keypads are routine parts and the repair is usually worth doing. A magnetron or a control board on an inexpensive countertop unit is where the part costs more than the machine, and we will tell you that rather than quoting it.
Built-in and over-the-range units are a different calculation: replacing one means matching the opening and the trim, so repairing is often the better value even at a higher part cost.
Blackhawk, Falcon Pointe, Avalon, Sorento, Highland Park, Commons at Rowe Lane, Lake Pflugerville, Windermere, Heatherwilde, Springbrook, Verona, Villages of Hidden Lake, and the newer streets along Toll 45 and SH 130.
For an over-the-range or built-in unit, usually yes, because replacement means matching the opening and often the cabinet. For a countertop unit, a magnetron or board replacement rarely makes sense. We will tell you which category yours falls into before anything is ordered.
Because the fuse was the symptom. Something caused it, usually a door interlock switch that failed shorted. A repair that replaces only the fuse has not found the fault yet.
No. Arcing burns the cavity and takes the magnetron with it. Unplug it and have the waveguide cover and cavity looked at, which is usually a small repair if it is caught early.
Nine to ten years. Above a cooktop that gets heavy use, closer to seven, because the heat and grease reach the keypad, the fan and the board. Cleaning the grease filters regularly adds real life to one of these.
Many in Pflugerville do not. Look inside for a charcoal filter above the grease filter, and look for a cap on the roof or an exterior wall. If it is recirculating, the charcoal filter has to be replaced rather than washed, and that alone fixes most complaints about the fan not doing anything.
Tell us the brand, whether it is over the range or countertop, and whether the problem is heating, the panel or the fan, and we can usually narrow it down before we arrive. Call (737) 388-3867 or book online. The ninety nine dollar diagnostic is credited toward the repair.
We repair all major residential appliance brands across Central Texas, including Whirlpool, GE, Samsung, LG, Maytag, Frigidaire, KitchenAid, Amana, Bosch, Electrolux, Hotpoint, Kenmore, Haier, Fisher & Paykel, Sub-Zero, Wolf, Viking, Thermador, JennAir, Dacor, U-Line, Marvel, Miele, and GE Monogram.