Pflugerville has two housing stories and they fail differently. Windermere, Heatherwilde and the older streets off Pecan have appliances that were swapped into openings built for something else. Blackhawk, Falcon Pointe, Avalon and Sorento have whole subdivisions of builder installed refrigerators that all went in the same year and are now reaching the same age together.

In almost every modern refrigerator both compartments are cooled by one evaporator in the freezer, and a fan moves that cold air forward. A cold freezer with a warm fridge is therefore an air delivery problem: the evaporator fan, a damper that is not opening, or frost blocking the air path. The sealed system is usually fine, and that matters because those two repairs are very different numbers.
Slabs move on the clay soil here, and a kitchen floor that has shifted even slightly puts a heavy French door unit out of square. The door then stops sealing at one corner, humidity gets in, and the unit frosts and runs long. The honest first step is a level and a gasket check, not a part, because adjusting feet and hinges fixes a surprising number of these calls.
A second refrigerator in a west facing garage is working in air far hotter than it was designed for. Standard units are rated for a normal room, and above that the condenser cannot shed heat, so it runs continuously and still loses temperature. Garage ready models exist for this reason, and if the one out there is not one of them, no repair will make it behave like one.
Frost on the interior back wall means moisture is getting in or defrost is not clearing the coil. A door gasket that has taken a set, a door left ajar on a full load, or a failed defrost heater, thermostat or control. In a busy family house where the door gets opened constantly, the gasket is the first place to look and the cheapest to fix.
Continuous running has two very different causes. A condenser coil packed with dust and pet hair means the heat has nowhere to go. A refrigerant or restriction problem in the sealed system means the same thing for a completely different reason. Pressures and the coil get checked together before anyone says the word compressor.
Defrost water is supposed to drain through a small channel and tube into a pan under the unit. When that drain blocks with debris, or freezes solid at the top, water backs up into the bottom of the fresh food compartment. It is a straightforward repair and worth doing early, because standing water eventually reaches the floor and the liner.
Slow flow is usually a loaded filter or a line partly frozen where it passes through the door. Dripping after release is normally air in the line or a valve that is not seating. Neither is dramatic, but both are worth sorting, because a valve that no longer closes properly is how a kitchen floor gets ruined overnight.
In the newer subdivisions we see the same model fail on the same street within a few months of each other, because they were all installed at once and they all have the same weak point. That is useful rather than depressing: once we know the model, we usually know what failed before we open it, and whether the part is worth putting into a unit of that age.
French door and side by side units, top and bottom freezer models, built in and counter depth refrigerators, garage refrigerators, and standalone and deep freezers. Common brands include Whirlpool, Samsung, LG, GE, KitchenAid, Frigidaire, Maytag, Bosch, Electrolux and Sub Zero.
Built in units come out and go back into their cabinetry as part of the job, and on a counter depth install we check the clearances, because a unit crowded into an opening runs hot regardless of its condition.
The diagnostic is ninety nine dollars for a residential call, credited toward the repair once you approve the work. Fans, dampers, defrost components, gaskets, hinges, valves and filters are routine repairs. Sealed system work or a compressor is a much larger decision, and on a unit that is already eight or ten years old we will tell you plainly when it stops making sense against a replacement.
If the real problem is a door out of level or a crowded opening rather than a component, you will hear that instead of paying for a part that changes nothing.
Blackhawk, Falcon Pointe, Avalon, Sorento, Highland Park, Commons at Rowe Lane, Lake Pflugerville, Windermere, Heatherwilde, Springbrook, Verona, Villages of Hidden Lake, and the newer streets along Toll 45 and SH 130.
Usually not. Check whether the unit is level first, side to side and front to back, and look at whether the gasket is flattened at one corner. Floors move here, and a unit that is out of level by a small amount will stop sealing long before anything inside it fails.
It depends on whether it is garage rated. If it is, repairing is normal and worthwhile. If it is a standard indoor unit living in a hot garage, it will keep failing every summer no matter what we replace, and the honest answer is a different unit rather than another repair.
Twice a year is reasonable, and more with pets. It is the single highest return thing you can do for a refrigerator, and on the newer builder installed units with the coil behind a bottom grille it is easy to reach.
Ten to fifteen years for a unit in a conditioned kitchen. Builder grade models in a hot garage live a much shorter life, and the difference is almost entirely heat on the condenser.
Very. Whole streets here were finished with the same appliance package, so the same weak component reaches the end of its life at roughly the same time. It also means we often know the likely failure and the part availability before we arrive.
Tell us the brand, whether the freezer is still cold, and roughly how old the unit is, and we can usually narrow it down before we arrive. Call (737) 388-3867 or book online. The ninety nine dollar diagnostic is credited toward the repair.
We repair all major residential appliance brands across Central Texas, including Whirlpool, GE, Samsung, LG, Maytag, Frigidaire, KitchenAid, Amana, Bosch, Electrolux, Hotpoint, Kenmore, Haier, Fisher & Paykel, Sub-Zero, Wolf, Viking, Thermador, JennAir, Dacor, U-Line, Marvel, Miele, and GE Monogram.